从本处下载的NX7.5及NX8.0软件,安装和启动都正常,但进入MOLDWIZARD模块后,发现流道(RUNNER)功能
不能用。当你点击该图标时即弹出信息框,提示“Failed to find the cross section data. Make sure it is located
in the fill floder of the MoldWizard data base.” 当你将MOLDWIZARD数据库安装后再试该功能时,仍弹出上述
信息框。经与NX6的MOLDWIZARD对比,未觉得缺少数据, 所以搞不清楚是不是NX7.5及NX8.0解密不完全还是尚存
小问题。 盼老师及高手指点!